BRP can-am OUTLANDER 2024 Operator's Manual page 149

2. Press and hold the override/DPS button then press the throttle lev-
er gradually.
3. When using the override function, the gauge will scroll an OVER-
RIDE message to confirm that the function is activated.
4. To disengage the override function, simply release the override/
DPS button.
D D P P S S F F u u n n c c t t i i o o n n
This button is also used to change the Dynamic Power Steering (DPS)
mode.
For complete information on DPS modes, refer to Tune Your Ride .
W W i i n n c c h h C C o o n n t t r r o o l l S S w w i i t t c c h h ( ( i i f f e e q q u u i i p p p p e e d d ) )
To let out the cable, press the switch down.
To reel in the cable, press the switch up.
S S p p e e e e d d L L i i m m i i t t e e r r C C o o n n t t r r o o l l ( ( i i f f e e q q u u i i p p p p e e d d ) )
Speed limiter mode allows the operator to set a maximum speed that
cannot be exceeded when riding.
This is useful to help the driver not to exceed certain limit, but it also
helps to maintain a more constant speed when performing tasks with
the ATV or when riding.
The operator can always vary the speed from 'Stop' position to the set
speed using the throttle.
SECONDARY CONTROLS
147