BRP can-am OUTLANDER 2024 Operator's Manual page 136

SECONDARY CONTROLS
Before passing in 2WD or in 4WD modes:
1. Stop the vehicle completely.
2. Let the engine idling.
3. Select desired mode.
F F r r o o n n t t d d i i f f f f e e r r e e n n t t i i a a l l d d a a m m a a g g e e m m a a y y o o c c c c u u r r i i f f t t h h e e 2 2 W W D D / / 4 4 W W D D s s e e l l e e c c t t o o r r
i i s s u u s s e e d d w w h h i i l l e e v v e e h h i i c c l l e e i i s s m m o o v v i i n n g g . .
M M o o d d e e l l s s w w i i t t h h 4 4 W W D D L L o o c c k k M M o o d d e e
To engage or disengage the 4WDLock mode:
1. Make sure 4WD mode is selected.
2. Reduce your speed under 30 km/h (20 MPH).
3. Release the throttle.
4. Momentary fully press the selector up.
5. To disengage the 4WDLock mode, press the selector up again.
When the 4WDLock is activated, the telltale on the throttle lever con-
trol housing and the icon in the digital display will turn on and a beep
sound will be heard.
N N O O T T E E : :
If the telltale flashes then stays off, the request is not acknowledged.
Reduce your speed under 30 km/h (20 MPH), release the throttle and
try again.
2 2 W W D D M M o o d d e e
In this mode, the engine power is transferred through the rear wheels
only.
To engage the 2WD mode, press the selector D D O O W W N N .
134
N N O O T T I I C C E E