R R e e f f e e r r t t o o a a n n a a u u t t h h o o r r i i z z e e d d C C a a n n - - A A m m O O f f f f - - r r o o a a d d d d e e a a l l e e r r . .

If vehicle has no damage, refer to Maintenance Procedures and in-

spect the following.

– Inspect air filter housing for oil accumulation, if any oil is found,

clean air filter and air filter housing.

– Check engine oil level and refill if necessary.

– Check engine coolant level and refill if necessary.

– Check gearbox oil level and refill if necessary.

– Check rear final drive oil level and refill if necessary.

– Start engine. If the oil pressure light stays on, stop engine immedi-

ately. See an authorized Can-Am Off-road dealer.

Whenever the vehicle is turned over, it should be inspected by an au-

thorized Can-Am Off-road dealer.

V V e e h h i i c c l l e e i i s s I I m m m m e e r r s s e e d d i i n n W W a a t t e e r r

Should the vehicle become immersed, immediately stop the engine.

Do not use any electrical equipment, including the winch.

It will be necessary to take the vehicle to an authorized Can-Am Off--

road dealer as soon as possible. N N E E V V E E R R A A T T T T E E M M P P T T T T O O S S T T A A R R T T

T T H H E E E E N N G G I I N N E E ! !

I I m m m m e e r r s s i i o o n n o o f f t t h h e e v v e e h h i i c c l l e e c c a a n n c c a a u u s s e e s s e e r r i i o o u u s s d d a a m m a a g g e e i i f f t t h h e e c c o o r r - -

r r e e c c t t r r e e s s t t a a r r t t p p r r o o c c e e d d u u r r e e i i s s n n o o t t f f o o l l l l o o w w e e d d . .

As soon as vehicle is pulled out of water, carry out the following:

– Inspect the air filter housing to make sure water has drained.

– Drain CVT, refer to Water Into the CVT .

200

W W A A R R N N I I N N G G

N N O O T T I I C C E E

Table of Contents