BRP can-am OUTLANDER 2024 Operator's Manual page 302

MAINTENANCE PROCEDURES
2. Position vehicle on a level surface, 7.6 m (25 ft) in front of a test
surface (wall or screen) as in first illustration.
3. Measure the distance from the center of each headlight to the
ground (high beam and low beam).
4. Trace a line on the test surface parallel to the ground at each
measured height (one for high beam and one for low beam).
Low beam aiming is correct when the cutoff at the top of the beam
is on the applicable horizontal center line on the test surface.
High beam aiming is correct when the center of the high beam (fo-
cus point) is 64 mm (2.5 in) b b e e l l o o w w the applicable horizontal center
line traced on the test surface as per specification.
N N O O T T E E : : The headlights can only be adjusted vertically.
1. High beam focus point
A. Distance between headlamps and the test surface
B. Beam aiming specification
5. To adjust, turn the adjustment screw.
300