Table of Contents
Advertisement
4. MAINTENANCE
STEP 4)
REMOVING THE SPINDLES
A. Once the Shaft Blocking Tool is in place, use the
Aluminum Spindle Screws Slotted Nut on a torque
wrench to remove the Spindle Screws (Pos. 2180)
on the drive and driven shafts.
B. In the event that the spindles get stuck, simply
use a Rubber Mallet to knock them loose. Hit
one side, then the other, alternating until driven
loose.
C. WARNING!
DO NOT USE A METAL HAMMER.
DOING SO WILL CAUSE DAMAGE!
PROCESSTEC INC. 2022
Page 53
Advertisement
Table of Contents
