Table of Contents
Advertisement
4.3.2 Recommended Tools
The recommended tools at hand are Tools for 130 ML-2 use only. (Please see Section 5.1 "Tools" on page
75 for more information)
4.3.3 Recommended Oils, Grease
The quality of the bearing oil greatly influences the service life of the pump, especially pumps operating in
humid environments with many starts and stops. Please study Section 6.4 "Maximizing Bearing Lifespan"
on page 108.
It is important to notice that not all oils can be mixed. Synthetic oils based on Polyglycol have water absorbing
properties that greatly increase service life, but cannot be mixed with oils based on Polyalphaolifin.
recommends Klubersynth UH1-6 150 for
Processtec
absorbing properties. Its viscosity covers a large temperature range. The max temperature is 140° C.
ViscoTwin 130
The
requires 1.0 liter gear oil.
In cold locations like receiving bays,
normally indicated with numbers 68 or 100. For warmer processing environments, we recommend a more
viscous oil indicated with numbers 150.
For more information on Oils, please see to Section 5.6 "Oils, Grease & Lubrication Recommended" on
page 102.
PROCESSTEC INC. 2022
ViscoTwin
recommends the selection of the lower end viscocity,
Processtec
4. MAINTENANCE
pumps. It's a foodgrade oil with water
Page 47
Advertisement
Table of Contents
