Nvr50-Ei Series - Dahua NVR5208-EI User Manual

Table of Contents

Advertisement

Icon
B
CTRL (CTRL 12 V)
P (+12 V)
RS-232
VGA
PoE PORTS

2.2.33 NVR50-EI Series

The NVR50-EI series rear panel is shown as below.
Name
RS-232 debug COM
VGA video output port
78
Function
RS485_B. It is the cable B. You can connect to
the control devices such as speed dome PTZ.
Controller 12 V power output.
It is to control the on-off alarm
relay output. It can be used to
control the device alarm
output. At the same time, it
can also be used as the power
input source of some devices
such as the alarm detector.
+12 V power output port. It
can provide the power to
some peripheral devices such
as the camera or the alarm
device. Please note the
supplying power shall be
below 1 A.
It is for general COM debug to configure IP
address or transfer transparent COM data.
VGA video output port. Output analog video
signal. It can connect to the monitor to view
analog video.
Built-in Switch. Support PoE or ePoE function.
For ePoE series product, port 1 to port 8 are the
ePoE ports. ePoE port supports 300
meters@100Mbps, 800 meters@10Mbps. Port 9
to port 16 are general PoE ports.
The 16 PoE series supports total 150W.
User's Manual
The two ports
serve as
another group
of alarm output
ports.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nvr5816-16p-eiNvr4416-4ks2/i.proNvr5816-eiNvr5416-ei

Table of Contents