Table of Contents
Advertisement
Step 2
Configure parameters.
Parameter
Channel
Type
Protocol
Address
Baud rate
Data Bit
Stop Bit
Parity
Step 3
Click Apply.
5.6.7.2 PTZ Control
You can use the PTZ control panel to perform the operations such as directing camera in eight
directions, adjusting zoom, focus and iris settings, and quick positioning.
Figure 5-39 PTZ (remote)
Table 5-12 PTZ parameters
Description
Select the channel that you want to connect the PTZ camera to.
Local: Connect through RS-485 port.
●
Remote: Connect through network by adding IP address of PTZ camera
●
to the Device.
Select the protocol for the PTZ camera such as PELCOD.
Enter the address for PTZ camera. The default is 1.
The entered address must be the same with the address configured on the
PTZ camera; otherwise the system cannot control PTZ camera.
Select the baud rate for the PTZ camera. The default is 9600.
The default value is 8.
The default value is 1.
The default value is None.
156
User's Manual
Advertisement
Table of Contents
