Dahua NVR5208-EI User Manual page 474

Questions
NVR cannot control PTZ.
I cannot log in client-end or
web.
There is only mosaic no video
when preview or playback
video file remotely.
Network connection is not
stable.
Burn error /USB back error.
Keyboard cannot control NVR.
Reasons
Front panel PTZ error.
●
PTZ decoder setup, connection or installation is not correct.
●
Cable connection is not correct.
●
PTZ setup is not correct.
●
PTZ decoder and NVR protocol is not compatible.
●
PTZ decoder and NVR address is not compatible.
●
When there are several decoders, add 120 Ohm between the
●
PTZ decoder A/B cables furthest end to delete the
reverberation or impedance matching. Otherwise the PTZ
control is not stable.
The distance is too far.
●
For Windows 98 or Windows ME user, update your system to
●
Windows 2000 sp4. Or you can install client-end software of
lower version. Please note right now, our NVR is not
compatible with Windows VISTA control.
ActiveX control has been disabled.
●
No dx8.1 or higher. Upgrade display card driver.
●
Network connection error.
●
Network setup error.
●
Password or username is invalid.
●
Client-end is not compatible with NVR program.
●
Network fluency is not good.
●
Client-end resources are limit.
●
Current user has no right to monitor.
●
Network is not stable.
●
IP address conflict.
●
MAC address conflict.
●
PC or device network card is not good.
●
Burner and NVR are in the same data cable.
●
System uses too much CPU resources. Stop record first and
●
then begin backup.
Data amount exceeds backup device capacity. It might result
●
in burner error.
Backup device is not compatible.
●
Backup device is damaged.
●
NVR serial port setup is not correct.
●
Address is not correct.
●
When there are several switchers, power supply is not
●
enough.
Transmission distance is too far.
●
458
User's Manual