Dahua NVR5208-EI User Manual page 374

Step 2 Click to enable the function.
Step 3 Configure the parameters.
Parameter Description
Select the checkbox of SNMP version that you are using.
Version
The default version is V3. There is a risk if you use V1 or V2.
SNMP Port Enter the monitoring port on the agent program.
Read Community
Enter the read and write strings supported by the agent program.
Write Community
Enter the destination address for the agent program to send the Trap
Trap Address
information.
Enter the destination port for the agent program to send the Trap
Trap Port
information.
Enter the username that is allowed to access the Device and has the read-
Read-Only Username
only permission.
Figure 5-235 SNMP
Table 5-68 SNMP parameters
358
User's Manual