Table of Contents
Advertisement
CHAPTER
24
Programming an AutoRAE 2 on the computer
When it comes to an AutoRAE 2 Controller-based system configuration, some parameters, such
as date and time, can be configured either on the PC or directly on the Controller screen. Other
parameters, such as the AutoRAE 2 system password can only be configured directly on the
Controller, whereas gas configurations (gas inlet settings), can be only configured on a PC.
Firmware updates for both the Controller and all the Cradles connected to it can also only be
done on a PC.
To program an AutoRAE 2 Controller-based system on a PC, you need Safety Suite Device
Configurator Software, the AutoRAE 2 Controller-based system connected to a power source,
and a USB PC communications cable.
1. Connect a USB cable between a PC with Safety Suite Device Configurator (SSDC) and the
AutoRAE 2 Controller.
2. Turn on the AutoRAE 2 Controller (with AC adapter connected and plugged in, power switch
toggled so red LED light is glowing).
3. Start Safety Suite Device Configurator (SSDC) software on the PC.
4. Login with your username and password. By default the user name is "administrator" and
the password will be "Default123".
5. The program will begin performing a Startup Scan for any connected devices.
6. Locate the device on the device list and Click on the device's serial number.
AutoRAE 2
PROGRAMMING AN AUTORAE 2
108
User Manual
Advertisement
Table of Contents
