Table of Contents
Advertisement
System settings
In Advanced Mode, you can make changes to the system's settings.
System Settings (Advanced mode only) allow you to access the following:
Controller information
This is read-only information about the AutoRAE 2 Controller:
Model
l
Serial Number
l
Firmware
l
Built
l
Date
You can set the date according to the format set in Safety Suite Device Configurator (SSDC).
Press [Y/+] to advance through numbers 0 through 9.
Press [N/-] to advance to the next digit.
Press [MODE] to save the new date.
Note: If you have already set the date by using Safety Suite Device Configurator (SSDC), you do
not need to set the date again. This screen is useful for checking that your date stamps are
correctly set.
AutoRAE 2
104
User Manual
Advertisement
Table of Contents
