Wall Mounting - Honeywell Lyric LCP500-LC Installation And Reference Manual

Lyric Controller Installation and Reference Guide
Installing the Control Installing the Control (Continued)
Installing Installing the Control the Control
4. Disconnect the battery pack connector from the receptacle on the back of the controller.
5. Remove the screw that secures the battery retainer and remove the battery retainer.
6. Remove the battery pack from the back case.
Install the replacement battery Install the replacement battery Install the replacement battery Install the replacement battery
1. Install a replacement battery pack LCP500-4B (p/n 300-03864-AIO) OR LCP500-24B (p/n 300-03866-
AIO) into the back of the controller.
2. Install the battery retainer.
3. Secure the battery retainer with the provided screw.
4. Connect the battery pack connector to the receptacle on the back of the controller.
5. Align the slots on the back of the controller with the hooks on the wall mount as shown below.
6. Once attached, insert the screw to secure the Lyric to the wall mount.
NOTE: NOTE: NOTE: NOTE: If a Cellular Communication Module is being installed, verify the module's signal strength before
selecting a final mounting location. Refer to Checking the Signal Strength in the Communications
Module section.

Wall Mounting

Wall Mounting Wall Mounting Wall Mounting
NOTE: When selecting a location for the Lyric Controller, be sure to provide a separation of at least 10 feet NOTE: NOTE: NOTE:
between 2.4GHz devices such as Wi-Fi Routers/Access Points.
For wall mounting follow the steps and refer to the figure below.
1. Feed the field wiring through the appropriate openings in the wall mount.
2. Attach the wall mount to a sturdy wall using the four provided screws.
3. If required, install an additional mounting screw in the case tamper.
4. Align the slots on the back of the controller with the hooks on the wall mount as shown below.
5. Once attached, insert the screw to secure the Lyric to the wall mount.
MOUNTING
SCREW (4)
TYP.
TAMPER
SCREW
(OPTIONAL)
WALL
SURFACE
INSERT SCREW
(IF APPLICABLE)
- 8 -
WALL
MOUNT
lyric-036-V1