Table of Contents
Advertisement
CHAPTER
7
PREPARING CRADLE
Preparing cradle for bump testing & calibration
Before performing a bump test or calibration, the AutoRAE 2 Cradle must be set up, filter
installed, and power applied. In addition, it must be configured using Safety Suite Device
Configurator (SSDC) software to set the gas types and concentrations, as well as the time and
date. See "Programming a cradle" on page 52 for more information..
Installing an external filter
In order to ensure that fresh air is uncontaminated by dust or other materials, use a filter on the
AutoRAE 2 Cradle's fresh air inlet. The inlet is located on the top end, to the left of the locking
mechanism. Inspect the filter periodically and replace it as necessary if dirty, damaged, or
contaminated.
Press filter onto receptacle
NOTE: Remove charcoal filter between uses and store in plastic bag for best practice.
AutoRAE 2
28
User Manual
Advertisement
Table of Contents
