Before First Use - Tesla Cyclone Silent PRO BGL400BR User Manual

Before first use

First, Put battery into the remote control compartment - this product comes with a remote control battery. Before using this
product, please put the battery into the compartment of the remote control handle grip. Gently open the battery cover as
shown in Fig a, put two AAA 1.5 V battery into the compartment of remote control as shown in Fig b. cover the battery lid as
shown (fig c).
Second, Connect the vacuum cleaner and cleaner according to the speed control button, Until the display screen on a beat
pattern, then press any button control handle, the handle can realize the wireless remote control function.
Please make sure that the battery "+" and "-" no reverse polarity. When the vacuum cleaner is not used for a
NOTE
long time, please take out the battery from the remote control compartment.
a
How to use the Speed control handle operation
The remote has three buttons can be used to operating a vacuum cleaner, with "+" and "-" button can adjust the size of the
suction of vacuum cleaner (Fig d, Fig e), with a button on the product can be switch to standby mode (Fig f).
NOTE
• Only in the switch button the product itself is opened, the remote control will take efect.
• When press any button on the remote control, the indicator light on the remote control doesn't light up, should replace
the battery, please refer to the chapter "before first use".
d
Fig.1 shows the connection of the hose and the vacuum cleaner: Put the hose connector in front of the vacuum cleaner.
Then insert it into the inlet hole and turn right. If you want to disassemble it, you can turn the hose connection left and then
pull it out.
Fig.2 shows the connection of the hose and the extending metal tube: Hold the flexural connector of the hose and put it
into the bigger hole of the tube.
Fig.3 shows the connection of the tube and the brush tool:
Put the metal tube into the hole of the brush and rotate it to fasten them.
Fig.4 shows how to check the winding of the power cord.
You can pull the power cord out of the machine and stop it when you see the yellow mark. Make sure the red mark is not out.
When your sweep is over, first turn off the power, pull the plug out of the socket, and then push the winding device button
until the cord is completely in the machine.
Fig.5 shows the power button
Put the plug into the socket, push the power button to control the work of the machine.
Fig.6 shows the vacuum power
Use the symbols on the vacuum power display as a guideline, press the add button (increase vacuum power) or the minus
button (reduce the vacuum power).
b
e
c
f
3