Remote Controler - Tesla RoboStar iQ300 Manual

REMOTE CONTROLER

BEFORE FIRST CLEANING
•
Remove the two foam stops located on the bumper of the vacuum cleaner.
•
Remove all obstacles that can prevent effective cleaning.
•
Also remove objects that can damage the robotic vacuum cleaner.
•
The carpet must be secured so the robot cannot get on it when mopping. If the mopping pad with
the water container is installed on the vacuum cleaner, it may interrupt the cleaning process or
cause unwanted soaking of the carpet.
•
Direct sunlight may cause a reduced sensitivity of the infrared sensors of the vacuum cleaner,
please avoid direct sunlight light.
•
Black furniture may not be properly detected due to the physical nature of infrared sensors. This
may cause a slight impact, which will be reduced by the front bumper.
•
The top of the vacuum cleaner is tempered glass. Although toughened glass is safer and stronger
than standard glass, please handle it carefully so as not to scratch or brea k it.
Ideal location of the charging base
There must be no obstacles within 2 meters in front and 1 meter on the sides from the charging
station. The charging station must be placed on a flat surface, we also recommend to fix the station to
the wall or floor with a double-sided adhesive tape. Place the power cord so it does not get entangle in
the cleaning brushes of the vacuum cleaner. A mirror or other objects with strong reflection can not be
placed in the area of the charging base 15 cm above the ground . The base should not be exposed to
direct sunlight.
1. Insert the batteries into the remote control, observing the correct polarity.
2. Install the cleaning brushes, left (L) and right (R) as indicated.
3. Connect the charging station to a power outlet using the 230 V AC adapter
1 Display
2 SMART cleaning
3 Start/Pause cleaning
4 Adjusting suction power
5 Time setting
6 Water moping
7 Return to charging station
8 Direction buttons
9 SMART cleaning with maximum performance
10 Cleaning along the walls
11 Planned cleaning