Tesla RoboStar iQ300 Manual page 96

Vacuum cleaner
stuck during
2
cleaning.
The vacuum
cleaner stops
cleaning and
returns to the
3
charging base
prematurely.
The vacuum
cleaner will not
start cleaning as
scheduled.
4
Remote control
5 does not work (RC
range is 5 meters)
The charging base is not
connected to the mains and the
vacuum cleaner is switched on by
the main switch.
The battery is completely
discharged.
The vacuum cleaner is stuck in a
small space, wrapped loose
objects such as curtains, carpet,
etc. on the cleaning brushes.
If the battery level decreases, the
vacuum cleaner will automatically
switch to charging dock and return
to the charging base.
The operating time varies
depending on the floor surface, the
complexity of the room and the
cleaning mode selected.
The vacuum cleaner is switched
off or the battery is low.
You have not saved the scheduled
cleaning in the vacuum cleaner
memory.
The vacuum cleaner is blocked.
Weak batteries in remote control.
The vacuum cleaner is not
switched on or the battery is not
sufficiently charged to start
cleaning.
The infrared sensor on the remote
control is dirty or the infrared
sensor on the vacuum cleaner is
dirty.
There is interference between the
remote control and the vacuum
cleaner.
The charging base should always
be connected to the mains, do
not turn it off. The vacuum
cleaner is then always ready for
cleaning with a fully charged
battery.
Connect the robotic vacuum
cleaner directly. Plug the power
cord from the 230 V supply into
the charging connector on the
device body.
The vacuum cleaner
automatically tries to release it if
it is unable to do so, please clear
the obstacle yourself.
Normal condition, charge the
vacuum cleaner to its full
capacity and start cleaning
again.
Normal state, there is no need to
solve.
Turn on the vacuum cleaner and
charge the battery.
Re-enter the time and day in the
vacuum cleaner memory and
make sure that the vacuum
cleaner is fully charged.
Switch off and clean the vacuum
cleaner.
Replace the batteries, observing
the correct polarity when
inserting them.
Make sure the vacuum cleaner is
turned on and recharge the
vacuum cleaner battery.
Clean the remote control and
vacuum cleaner.
Avoid using near other infrared
devices.