Placing Calls - Tadiran Telecom T49G User Manual

Placing Calls

You can place a call in one of three ways using your T49G IP phone:
Using the handset
-
Using the speakerphone
-
Using the headset
-
You can also dial the number first, and then choose the way you want to speak to the
other party.
By default, you can set up a video call with the other party that is video-enabled. The IP
phone can set up video calls with only two parties (even if more than two parties that
set up a call with you can send video). To place an audio-only call, make sure the video
feature is disabled. For more information, refer to
73.
During a call, you can alternate between Speakerphone, Headset, and Handset modes
by pressing the Speakerphone key, the HEADSET key, or by picking up the handset.
The call duration of the call and far-site's information (name or phone number) are
visible on the touch screen. In the figure below, the call to "Habas Duo" has lasted 7
seconds.
Note
The phone will enter the video call full-screen within 5 seconds during a call, you
may tap
To place a call using the handset:
1. Pick up the handset.
2. Enter the desired number using the keypad or the soft keyboard on the touch
screen.
You can enter the number using the onscreen keyboard.
or blank area at the top or bottom of the screen to see the soft keys.
Basic Phone Features
Changing the Video Settings on page
63