Placing Calls - Tadiran Telecom T41P User Manual

Placing Calls

You can place a call in one of three ways using your T41P IP phone:
Using the handset

Using the speakerphone

Using the headset

You can also dial the number first, and then choose the way you want to speak to the
other party.
During a call, you can alternate between Speakerphone, Headset, or Handset mode by
pressing the Speakerphone key, the Headset key, or by picking up the handset.
The call duration of the active call is visible on the LCD screen. In the figure below, the
call to the number"2002" has lasted 27 seconds.
To place a call using the handset:
1. Pick up the handset.
2. Enter the desired number using the keypad.
3. Press
The # key is configured as a send key by default. You can also set the * key as the send
key, or set neither.
Note
You can also dial using the SIP URI or IP address. To obtain the IP address of a phone,
press the OK key when the phone is idle. The maximum length of SIP URI or IP address
length is 32 characters. For example, SIP URI: 3606@sip.com, IP: 192.168.1.15.
Your phone may not support direct IP dialing. Contact your system administrator for more
information.
To place a call using the hands-free speakerphone mode:
Do one of the following:
- With the handset on-hook, press
Enter the desired number using the keypad.
Press
- With the handset on-hook, enter the desired number using the keypad.
Press
To place a call using the headset:
, , or the Send soft key.
, or the Send soft key.
, , or the Send soft key.
or the line key to obtain a dial tone.
Troubleshooting
19