Oneida Air Systems XCKM013000 Owner's Manual page 22

assembly Instructions (Continued)
Install Gasket (F18) around the top outer rim
17
of the Cone Assembly (B) [FIG. 17].
Note: Align the gasket notches over the notches
in the rim. Dust collection systems cannot
operate effectively if there isn't a complete seal.
There must be NO air leaks.
Secure Draw Latches (F15) to Cone Assembly
18
(B) with Pan Head Screws (F16) and Nylock
Nuts (F17) [FIG. 18].
Screw two Whiz-Lock Nuts (F20) up the shaft
19
of two J Bolts (F19). Then screw the J Bolts
onto the motor plate with the J Bolts pointing
out as shown in [FIG. 19a].
Note: When properly installed, the distance
between the motor plate and the top of the J bolt
is 1-11/16". [FIG. 19b]
Install Filter Retainer Strap (F21) onto the J
Bolts [FIG. 19c]
Note: If your filter retainer strap has steel
S-hooks on the ends, remove and discard. They
are not needed for the install.
20 Oneida Air Systems
FIG. 17
F17
F15
F16
FIG. 18
FIG. 19a
FIG. 19c
Top View
F18
Notches
F19
1
F20
FIG. 19b
F21
11/16"