Oneida Air Systems XCKM013000 Owner's Manual page 16

assembly Instructions (Continued)
Align each Stand Leg (E) to the Stand Body
4
(D) [FIG. 4a] and secure using four Carriage
Bolts (F1), four Washers (F2), and four Nylock
Nuts (F3) [FIG. 4b].
Choose one of the three holes on the Cone
5
Assembly (B) to store the Hose (K1) onto.
Turn Cone Assembly upside-down and install
one Carriage Bolt (F6), one Rubber Washer
(F7), two Flat Washers (F8), and a Whiz-Lock
Nut (F9) into the chosen hole as shown in
[FIG. 5a].
Then attach Vacuum Hose Storage Strap (F11)
to the Carriage Bolt and secure in place with
the Thumb Nut (F10) [FIG. 5a].
Insert a Push-in Plug (F12) into the two
remaining holes [FIG. 5b].
Note: Silicone (F13) can be applied to the Push-
In Plugs for a more permanent installation.
14 Oneida Air Systems, Inc.
FIG. 4a
FIG. 4b
F6 F7 F8 F9
B
FIG. 5a
F10
F11
FIG. 5b