Oneida Air Systems XCKM013000 Owner's Manual page 19

assembly Instructions (Continued)
Install the Quick-Disconnect Kit (F25) onto
11
the pre-drilled hole near the bottom section of
the Drum (I) [FIG. 11a].
Refer to the Quick Disconnect Installation
Sheet for more information.
Note: If you are not using the automatic bag
holding feature of the system, the Valve of
the Tube Assembly MUST be in the closed
position [FIG. 11b].
Place a Liner Bag (F36) inside the Drum
12
(I). Take care to ensure that the bag is fully
expanded to the inside of the Drum and that
the upper edge of the Liner Bag is folded out
and over the lip of the Drum [FIG. 12].
F25A F25B
F25C
FIG. 11a
Open
Closed
FIG. 11b
FIG. 12
oneida-air.com
F25D F25F
F25E
F36
I
17