assembly Instructions (Continued)
Slide the shorter end of the Tube Assembly
9
(F26A) onto the Nylon Elbow (F22) as shown
in [FIG. 9a].
Note: If you are not using the automatic bag
holding feature of the system, the Switch Valve
(F26B) of the Tube Assembly MUST be in
the closed position. Otherwise leave the Tube
FIG. 9a
Assembly in the open position [FIG 9b].
Open
Closed
FIG. 9b
Take the Tubing Assembly (F26) and route it
10
through the closest retaining hole located in
the back corner of the Stand Body (D) [FIG.
F26
F26
10].
Note: Which hole you use will be determined
Either Hole
by the orientation of your Cone Assembly (B).
D
Use whichever hole is closest to ensure adequate
length for the Tubing Assembly to connect to the
Drum (I).
FIG. 10
16 Oneida Air Systems