Table of Contents
Advertisement
assembly Instructions (Continued)
Attach the long end of the Tube Assembly
13
(F26C) onto the Nylon Elbow (F25A) installed
on the lower section of the Drum (I). Push
the Hose onto the fitting so that all barbs are
covered [FIG. 13].
Note: If you are not using the automatic bag
holding feature of the system, the Valve of
the Tube Assembly MUST be in the closed
position.
Attach the Flex Hose (G) to the inlet on the
14
Drum Lid (L) and secure it in place using a
Hose Clamp (F37). Loosely place a second
Hose Clamp onto the hose and then move the
Drum (I) underneath the Stand Body (D).
Connect the Flex Hose to the Collar (F28) and
secure in place. [FIG. 14].
Note: The Drum should be rotated so that the
inlet is closest to the wall to provide the best
visibility to the fill viewing window on the
Drum Lid.
18 Oneida Air Systems
F26C
F25A
F37
F37
FIG. 14
FIG. 13
F28
G
H
I
Advertisement
Table of Contents
