Oneida Air Systems XCKM013000 Owner's Manual page 15

assembly Instructions (Continued)
Install a Mounting Foot (F4) into the threaded
2
insert located on the bottom of each Stand Leg
(E) [FIG. 2].
Note: Firmly hand-tighten but do not over
torque as this may damage the connection point.
Locate the lower grouping of four mounting
3
holes on each of the Stand Legs (E). These will
be used to secure each Stand Leg to the Stand
Body (D) [FIG. 3a].
Note: The upper grouping of holes should be
only be used if you require the additional 4" of
height to attach the optional Drum Dolly to the
Drum (H) [FIG. 3b].
FIG. 2
FIG. 3a
oneida-air.com
FIG. 3b
13