Terminal Control Table (Available For Host Port Only); Type Definition - Unitech MR350 MKII Technical Reference Manual

address:
time-out:
4.5.

Terminal Control Table (available for host port only)

The terminal control table is meaningful only if the MR350MKII operation switch is
set to "terminal mode". All other operational modes ignore the terminal control
table.

4.5.1. Type Definition

The terminal control table is defined by the following typedef
TERM_CONFIG.
TERM_CONFIG data structure:
typedef struct { char terminal_id[8];
Each MR350MKII "terminal" is identified by an ASCII string. There
can be up to seven characters in a terminal identification string. The
'A' = terminal address ID for Multipoint mode
(default)
Each MR350MKII must be assigned a unique
communication address when it is used in a
Multipoint environment. The address is used by a
host or concentrator to perform polling functions.
Characters 'A'-'Y' and '0'-'6' are used for assigning an
address ID of each terminal.
'02' = polling time-out two cycle periods
(default).
'02'-'FF' in hex format.
The value of this setting is specified for the
communication time-out. If the MR350MKII does
not receive a response from the host system within
the number of time-out cycle periods, the
MR350MKII regards
unsuccessful and the transmission is then aborted. If
the time-out value is set to zero, no time-out check is
performed by the MR350MKII.
There is only
BYTE online;
BYTE echo;
BYTE autolf;
BYTE mode;
BYTE linepage; /* line or page block */
BYTE lineterm; /* line terminator */
BYTE pageterm;/* page terminator */
} TERM_CONFIG;
4-50
the communication
one instance of
/* terminal id */
/* auto LF */
as
the