Chapter 7. Supervisor Mode - Unitech MR350 MKII Technical Reference Manual

Chapter 7. Supervisor Mode

7. Supervisor Mode
The MR350MKII supports a Supervisor Mode to setup system configuration and
verify the hardware of the terminal.
Supervisor Mode:
1. Turn off the MR350MKII
2. Press [3] and hold the key, then turn on the power, or
3. Press [SHIFT] in conjunction with [F5/*] in Ready mode, then
4. Enter password. (DEFAULT : None, simply press [E])
The MR350MKII's LCD shows:
PASSWORD:
A supervisor password is used to prevent an unauthorized user from changing the
system configuration accidentally. The MR350MKII system will enter Ready mode
automatically if a user fails to enter the correct password within 5 tries. The default
password is none, simply press [E].
After the password check, the first screen in Supervisor Mode will be the first part
of the main menu, as shown below, the user may use [ ] to cycle through the first
and second parts of the main menu and select the number corresponding to one of
the eight categories to configure the system, reset the system or run diagnostics, or
press [F5/*] to go back to Ready mode.
1) DEVC
3) MEMY
First Part
1) DEVC
2) TERM
3) MEMY Memory Configuration
4) FNKY
5) AUTO
6) PSWD
7) INIT
2) TERM 5) AUTO 6) PSWD 9) BIOS
4) FNKY 7) INI
Device Configuration
Terminal Configuration
Define Function Key
Set Auto Execution program
Change Password
System Initialization (Cold Boot)
7-66
Follow the procedure below to enter
8) DIAG
Second Part