Barcode - Unitech MR350 MKII Technical Reference Manual

? ?
NOTE
1. The CTS/RTS option is only available when the RS-232 is assigned as
a serial port.
2. When XON/XOFF is selected as flow control, it will prompt 2 items
for user to set ASCII code of XON and XOFF

7.1.2. BARCODE

< DEVICE SETUP >
BARCODE
After press [E] key, the terminal will prompt in sequence to toggle ON or OFF the
accepting permission for the following barcode type: CODE39, I 2OF5,
CODABAR, UPC-A,UPC-E, EAN-13, EAN-8, CODE128, EAN128, CODE93.
The default permission for each type is ' ON' .
Press [ ] to toggle ON/OFF and then press [E] to confirm the selection. Below
show all detail setting of barcode symbology
CODE
Code 39
FULL Code 39
START/STOP
Check digit
I 2 of 5
Check digit
Codabar
START/STOP
Check digit
UPC-A
LEAD DIGIT
Check digit
UPC-E
LEAD DIGIT
Check digit
ZERO EXPAND
EAN-13
LEAD DIGIT
Check digit
EAN-8
Check digit
Code 128
EAN 128
Code 93
? ?
NOTE
Sub-item
ENABLE, DISABLE
ON, OFF
NO SEND, SEND
OFF, ON & No send, ON & Send
ENABLE, DISABLE
OFF, ON & No send, ON & Send
ENABLE, DISABLE
NO SEND, SEND
OFF, ON & No send, ON & Send
ENABLE, DISABLE
NO SEND, SEND
OFF, ON & No send, ON & Send
ENABLE, DISABLE
NO SEND, SEND
OFF, ON & No send, ON & Send
OFF, ON
ENABLE, DISABLE
NO SEND, SEND
OFF, ON & No send, ON & Send
ENABLE, DISABLE
OFF, ON & No send, ON & Send
ENABLE, DISABLE
ENABLE, DISABLE
ENABLE, DISABLE
7-68
Selection