Device Configuration; Rs485/Rs232 - Unitech MR350 MKII Technical Reference Manual

8) DIAG System Diagnostic
9) BIOS Update Firmware and programming user' s application program
7.1.

Device Configuration

To configure the MR350MKII device parameters, choose option "1) DEVC" in
Supervisor mode menu. The MR350MKII will prompt for following parameter
setting in sequence, RS485/RS232, BARCODE, WIEGAND and SECURITY.
User can use [ ] or [ ] key to select one item and then press [E] key to set it.

7.1.1. RS485/RS232

< DEVICE SETUP >
RS485/RS232
The MR350MKII will prompt in sequence to ask to select the COM port of the host,
protocol, address , baud rate, number of data bits, parity , number of stop bits and
flow control. The available options of each item are listed below and selections can
be made by pressing [ ] to cycle through available options and then press [E] to
confirm. Factory default values are underline and bold.
ITEM
COM1 selection
HOST PORT
HOST PROTOCOL
HOST Address
HOST Baud rate
HOST Data bits
HOST Parity
HOST stop bits
SERIAL Baud rate
SERIAL Data bits
SERIAL Parity
SERIAL stop bits
SERIAL Flow control NONE, XON/XOFF, CTS/RTS (if serial port is RS232)
into Flash Rom
RS485 , Ethernet
RS485 , RS232 or Ethernet, RS232
MULTI-POINT, NONE
' A' ~' Y' or ' 0' ~ ' 6'
110,150,300,600,1200,2400,4800,9600,19200,38400
8 , 7
NONE, EVEN , ODD
1,2
110,150,300,600,1200,2400,4800,9600,19200,38400
8 , 7
NONE, EVEN , ODD
1,2
7-67
SELECTION