Memory Configuration - Unitech MR350 MKII Technical Reference Manual

The setup method of the other system parameters in Terminal Configuration is
similar to the setting of ONLINE described above by using the [ ] key to toggle the
selection and pressing [E] to make the selection.
ECHO
AUTOLF
MODE
LINE/PAGE Use the [ ] key to choose among LINE, PAGE and BOTH.
The LINE/PAGE parameter is useful only if terminal MODE has
been specified as BLOCK mode. The LINE/PAGE entry designates
the termination characters. The termination character can be set as:
LINE Line termination: CR ( 0D hex)
PAGE Page termination: CTRL-Z ( 1A hex)
BOTH Both line termination and page termination.
LINETERM Assign Line terminator. Enter decimal sequence of an ASCII
PAGETERM Assign Page terminator. Assign using the same methods as
The system will go back to the first part of the main menu for the next selection.
7.3.

Memory Configuration

The MR350MKII system RAM memory is divided into three sections:
? System Variable Area
About 28KB of RAM is reserved for system parameters.
? RAM Disk
This area is used to store programs and data files similar to a physical
disk of a PC.
Use the [ ] key to choose between On and Off. The
collected data will be displayed on the MR350MKII LCD
when you set Echo to On, otherwise data will not be
displayed.
Use the [ ] key to choose between On or Off. When AutoLF
is set to On, the MR350MKII will append a LF (10 hex) code
to the input data field.
Use the [ ] key to choose between BLOCK and CHAR.
code, for instance enter "10" to assign the Line terminator as
a LF (linefeed) code.
shown in Line terminator above.
7-70