Unitech MR055 Ethernet Setup

Ethernet board

Ethernet Setup

Software needed:

Network Enabler Administrator v2.6

http://www.ute.com/files/software/38_NetworkEnabler.zip

OnlineCom Manager (or OnlineDll.dll)

http://www.ute.com/files/software/20_OnlineCommManagerSetup.exe

1. Connect an Ethernet cable to your MR350

2. Run Network Enabler Administrator

.a. Press the scan button to scan for the cradle once it is connected to your

network

.b. The Network Enabler Administrator software should see the cradle and

the IP address assigned to it. Double click this IP address for a new window

.c. Click on the "Network" tab and modify the IP address to match the IP

addresses distributed by your router. In this example, the router distributes

Table of Contents

Do you have a question about the MR055 and is the answer not in the manual?

Page 1 Ethernet Setup Software needed: Network Enabler Administrator v2.6 http://www.ute.com/files/software/38_NetworkEnabler.zip OnlineCom Manager (or OnlineDll.dll) http://www.ute.com/files/software/20_OnlineCommManagerSetup.exe Connecting the Cradle to your Network: 1. Connect an Ethernet cable to your MR350 2. Run Network Enabler Administrator Network Enabler Administrator: .a. Press the scan button to scan for the cradle once it is connected to your network .b.
Page 2 10.0.0.x IP addresses. You can enter the Gateway and a DNS Server 1&2 address. d. Now select the “Serial” tab and check the “Modify” box. Now click on the settings that appear below. A new window will pop up that will allow user to change baud rate, parity, data bits, stop bits and flow control.
Page 3 4. Run OnlineCom Manager or equivalent application that uses the “OnlineDll.dll”...
Page 4 Set the IP address and port to the settings saved by the Network Enabler Administrator application. Once connected, the OnlineCom Manager application will display the contents of the MR350 on the left side of the screen and the contents of the Note: If PC contents populate but receive “A:\?”...

Mr350