Using Terminal Block - Unitech Tashi Quick Reference Manual

Using Terminal Block

MT380 provides a 12-position terminal block for input/output signals.
1
Insert the stripped end of the wire into respective terminal block position of the
male plug (see diagrams following this section), then tighten the lock screw to
secure the wire.
2
Locate the I/O panel on MT380's rear cover, and remove the I/O panel by twist-
ing a Philips screwdriver on the cross mark (1). Then insert the terminal block
plug into the female socket of MT380 (2).
1
Copyright 2009 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
1
2
3
4
5
6
7
8
9
10
11
12
5
Lock Screw
2