Downloading Program In Point-To-Point Mode - Unitech MR350 MKII Technical Reference Manual

? ?
NOTE:
Please be noted, the MR350MKII can automatically detect the type of
badge reader. If a different type of build-in reader is selected, the first
attempt of reading the card will be used to detect the right type and the
data will not be accepted. If a right type is selected, the first attempt of
swiped data will be accepted immediately.
NOTE: Terminal wire link for Wiegand interface
Wiegand
+5V
Data1
GND
Data0
Remember to make jumper setting, J1/J2/J5/J6 Jumper need change to
pin2,3 on main board.
3.8.

Downloading Program in Point-to-point mode

Connect the Terminal in point-to-point mode through the RS-232 interface, then
follow the steps listed below to download a program to the Terminal:
Step 1. Connect a MR350MKII to a PC via the RS232 interface with the proper
cable.
Step 2. Press [F5/*] to invoke the user command menu.
Step 3. Select option "3) COM" to enter the Kermit server mode.
Step 4 Insert the demonstration diskette that may be obtained from your local
distributor into the PC.
Step 5. Run KERMIT on the PC.
Step 6. Use the send command from the PC to the MR350MKII to download the
Demo program, DRV350.EXE.
Terminal Block
?
P4A / +5V
?
P1A / M.S
?
GND
?
P1C / M.D
3-42