Wall Mounting The Terminal - Unitech MR350 MKII Technical Reference Manual

2.8.7. Wall Mounting the Terminal

This section will instruct you on how to install the MR350MKII on
the wall. All clearance dimensions are given in chapter 8 "Site
Preparation".
Installation Procedures:
(1) Drill all required holes.
(2) Route the signal cable which is attached to the terminal block
through the rectangular hole and connect it to your
communication line or device cable (see figure below)
Figure 2-21 Reassembling terminal using screws
Figure 2-22 Routing signal cable through backplate
2-35