Reassembling The Terminal - Unitech MR350 MKII Technical Reference Manual

2.8.6. Reassembling the Terminal

The MR350MKII is well suited for wall mounting, for mounting on
flat surface, or for placing on a table. The metal backplate is designed
as a back cover, with a wall mounting mechanism, thus you do not
have to purchase any additional accessories for wall mounting. If you
want to place the MR350MKII on a table or hang it on a wall, a
bench mounting kit is available.
If you plan to wall mount the MR350MKII terminal, you should skip
this section and go to the next section "Installing the Terminal on
Wall".
Installation Procedure:
(1) Lay the terminal front cabinet face down on a flat surface.
(2) Reconnect the terminal block adapter cable to the 24-pin
connector on the processor board.
(3) Carefully slide the backplate onto the front cabinet so that its
brackets mesh with the cabinet slots properly (see figure below).
(1) Lock the cabinet to secure the backplate to the front cabinet, or;
(2) If the security lock is not used, you may install the two screws
(one is a tapping screw, the other is a machine screw) that secure
the backplate to the front cover.
Figure 2-20 Reassembling terminal using security lock
2-34