Running Fast Commands From The Phone Keypad - Seneca MyALARM2 Series User Manual

MyALARM2 will call in sequence all the numbers in the address book enabled to receive the alarm in
progress; the call cycle will be interrupted when one of the recipients answers the call and confirms receipt
of the audio message by pressing the "*" key.
If no one in the group confirms receipt, MyALARM2 will restarting calling the first number in the group (for
a maximum of 3 times).
29.3.

Running fast commands from the phone keypad

MyALARM2 can be set to answer calls from numbers authorised to run commands (operator or
administrator).
After the audio welcome message, the fast command code is requested followed by "*".
For example, fast command "6" can be run by dialling:
6*
At this point, the guide voice will confirm whether or not the requested command is run.
An incorrect command can be cancelled by pressing the # key
ATTENTION!
• Once the fast command via audio call function is enabled, the "Zero cost ring command"
cannot be used since MyALARM2 security audio will answer the call.
USER MANUAL - MyALARM2 SERIES
71