14.
SUPPORTED COMMANDS
14.1.
SMS COMMANDS
14.1.1.
Some Smartphones send SMS with UNICODE characters instead of using the GSM alphabet.
MyALARM2 runs SMS commands with both GSM or UNICODE alphabet.
In most cases, SMS characters are set to GSM alphabet by default. If MyALARM2 does not recognise any
SMS command, check the alphabet used by the phone.
For Android smartphones:
Press the Message icon -> Settings -> Change writing -> GSM alphabet
14.1.2.
MYALARM2 lets you run commands if the SMS sender number is enabled (thus it must come from
an operator or administrator).
Command list:
SMS COMMANDS FOR DIGITAL INPUTS/COUNTERS/TOTALIZERS
GET DIN
GET DINn
GET DINn.TOT
GET DINn.CNT
RESET DIN
RESET CNTn
SET TOTn mmmmm...
USER MANUAL - MyALARM2 SERIES
SET THE TELEPHONE SMS CHARACTER ALPHABET
LIST OF SUPPORTED SMS COMMANDS
Forces the sending of an SMS with the status of
all digital inputs
Forces the sending of an SMS with the status of
the n-th input
Forces the sending of an SMS with the value of
the totalizer (possibly scaled) of the n-th input
Forces the sending of an SMS with the counter
value (possibly scaled) of the n-th input
Reset all counters
Reset the n-th counter
Load the mmmmm... scaled value in the nth
totalizer
38