Alarm Filter; Alarm Inhibition Time - Seneca MyALARM2 Series User Manual

17.4.

Alarm filter

A filter can be selected on the analog input, defined in seconds. The resulting effect is a filter on
both the alarm and reset, as illustrated below:
17.5.

Alarm inhibition time

An inhibition time on the next alarm can be set. Unlike the previous filter, the alarm is
immediately active but ignored during the alarm inhibition time. This time is reset after each
alarm.
ATTENTION!
DO NOT EXCEED THE FOLLOWING ANALOG INPUT VALUES OR THE INPUT STAGE COULD BREAK
AND VOID THE WARRANTY:
INPUT VOLTAGE: MAX VOLTAGE 35V
INPUT CURRENT: MAX VOLTAGE AT 12V HEADS (CURRENT PROTECTED)
USER MANUAL - MyALARM2 SERIES
ALARM ON MAXIMUM
ALARM ALARM
T inibiz T inibiz
T alarm
filter
T alarm
filter
ALARM ON MAXIMUM
55
ALARM
T inibiz