10.6.
Log SMS
Since only a limited number of characters can be sent via SMS, the SMS only includes the last row
of the log file and is, for example:
11/07/2012 11:17:00 +881 +10 +881 +10 +881 +10 +881 +10
Where the order of the values is given by the corresponding log file. In this case:
TIMESTAMP TOT1 DELTA TOT2 DELTA TOT3 DELTA TOT4 DELTA
Note: Log send priority is the following:
1) Log send via FTP/EMAIL
2) Log send via SMS
Thus log send via SMS can be used to be alerted when the log file was successfully sent via
FTP/EMAIL.
The content of the SMS log recalculates the datalogger configuration. To save characters, only
values without text TAGS are included.
ATTENTION!
-The SMS with the last log row can also be sent if file send on FTP failed (since the signal
required to send a log file is higher than the one needed to send an SMS), to analyse any FTP
server connection errors, enable the send error via SMS function.
-Since only 160 characters can be sent in an SMS, the log row may be truncated. In this case,
MyALARM2 adds "..." to indicate the end of available characters.
10.7.
TAG customisation in datalogger
All datalogger fields have a default TAG that can be set according to a few rules:
-The tag must start with a letter and not with a number
-The tag can be made up of a maximum of 7 characters
-Only letters, numbers and "_" are permitted in tags
Easy MyALARM2 setup software only lets you enter admitted characters automatically.
USER MANUAL - MyALARM2 SERIES
31