Gsm/Lte Signal - Seneca MyALARM2 Series User Manual

8. GSM/LTE SIGNAL

Through the display or through the Easy MyALARM2 software it is possible to know the GSM/LTE
signal level of MYALARM2 (in the configuration test section).
To view the GSM/LTE signal level, the SIM CARD supplied by the telephone service provider must
be inserted (signal may change radically based on the selected provider).
ATTENTION!
-Insert the SIM card with MyALARM2 off.
-Wait at least 5 minutes in order for the GSM/LTE signal to be correctly read.
The field can be inserted in the log files, in this case it is expressed in dBm where -115 dBm is the
minimum (0) and -52 dBm is the maximum (7).
Please refer to the following equivalence table:
For correct MYALARM2 operations used for ftp or email log, the minimum required field level is
2/7 (please remember that the signal often fluctuates).
For MYALARM2 operations used only via SMS, the minimum required field level is 2/7.
USER MANUAL - MyALARM2 SERIES
GSM/LTE
signal Signal [dBm]
0
(MINIMUM)
1
2
3
4
5
6
7
(MAXIMUM)
20
-115
-106
-97
-88
-79
-70
-61
-52