Zero Cost" Commands (Ring) - Seneca MyALARM2 Series User Manual

USER MANUAL - MyALARM2 SERIES
ENABLE ALARM ON STRING STREAM CONTROL Enables alarm on string stream control
DISABLE ALARM ON STRING STREAM CONTROL Disables alarm on string stream control
TEMPERATURE SENSOR TEMPERATURE SEND Sends the read temperature value
SEND STATUS MESSAGE Sends the machine status command with
settable content (see Easy MyALARM2
software)
SEND COUNTER VALUES Sends counter values
SEND TOTALIZER VALUES Sends totalizer values
ENABLE ALARM ON ALL DIGITAL INPUTS Enables alarm on all 4 digital inputs
DISABLE ALARM ON ALL DIGITAL INPUTS Disables alarm on all 4 digital inputs
SEND ANALOG INPUT VALUES Sends analog input values
For the full list of available commands, refer to the Easy MyALARM2 software.
14.3.

"ZERO COST" COMMANDS (RING)

MyALARM2 lets you run up to 2 actions tied to a ring from a classified number (thus from an
operator or administrator).
This mode lets you run "zero cost" commands.
The address book of phone numbers enabled to run "zero cost" commands can be extended to a
maximum of:
-250 users for the MyALARM 2, MyALARM2-1, MyALARM2-2 and MyALARM2-3 models
-1000 users for the MyALARM2-4 or successive models
To obtain this function, enable the "extended address book" function using the configuration
software.
NOTE
-To keep zero cost for MyALARM:
1) DO NOT answer the ring send by MyALARM2! The phone will ring for about 40 seconds after
which MyALARM2 automatically hangs up.
2) DO NOT hang up. The answering machine could be enabled!
47