Datalogger; Internal Clock - Seneca MyALARM2 Series User Manual

USER MANUAL - MyALARM2 SERIES

10. DATALOGGER

The Datalogger allows data to be acquired from the MYALARM2 built-in IO and sends the following
via FTP or email or saves it on microSD card:
.acquisition index
-Date/time
-the value of totalizers with the delta over the previous value.
-the real-time value of analog input with the minimum, maximum and average compared to the
last acquisition.
-the real-time value of digital inputs, power and battery status
-the real-time value of digital outputs
-the value of the internal or external temperature sensor (depending on the model)
-the value of the GSM/LTE signal
-GPS coordinates
-the meters linked to the digital inputs
10.1.

Internal clock

MYALARM2 is equipped with an internal clock/calendar. This clock can be synchronised:
-via Easy MyALARM2 software (in the "Test Configuration" section or when a new configuration is
sent)
-via an internet data connection
-via the GPS signal (depending on the model)
Either manual or automatic daylight savings time management can be selected.
Then the time is not reliable, the log continues to operate with a false date/time (starting from
01/01/1970) until the next synchronisation.
The time cannot be considered reliable when:
-MyALARM2 is turned on for the first time without be set.
-MyALARM2 batteries are dead.
23