Visualdsp++ Install And Session - Analog Devices Lite ADSP-21375 EZ-KIT System Manual

VisualDSP++ Install and Session

VisualDSP++ Install and Session
1-8
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from

To disconnect from the target board, click the terminate button
(red box) or choose Run > Terminate.
To delete a session, choose Target > Session > Session List. Select
the session name from the list and click Delete. Click OK.
For information about VisualDSP++ and to download the software, go to
www.analog.com/VisualDSP
1. Plug the provided power supply into
Visually verify that the green power LED (
2. Verify that the red reset LED (
then goes off, and, finally,
blinking.
3. Connect one end of the USB cable to an available full speed USB
port on your PC and the other end to
EZ-KIT Lite board.
4. Verify that the yellow USB monitor LED (
USB connector) is lit. This signifies that the board is communicat-
ing properly with the host PC and is ready to run VisualDSP++.
ADSP-21375 EZ-KIT Lite Evaluation System Manual
.
on the EZ-KIT Lite board.
J4
LED9
) goes on for a moment and
LED10
through
LED1 LED8
on the ADSP-21375
ZJ1
ZLED3
) is on.
are sequentially
, located near the