Push Buttons (Sw8-11); Board Reset Push Button (Sw12) - Analog Devices Lite ADSP-21375 EZ-KIT System Manual

Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
Push Buttons (SW8–11)
Four push buttons (
SW8—11
Two push buttons are connected to the
the other two are connected to the DAI of the processor. The push but-
tons are active high and, when pressed, send a high (
Refer to "LEDs and Push Buttons" on page 1-15
The push button enable switch (
buttons from corresponding processor pins. Refer to
Switch (SW7)" on page 2-13
The push buttons and corresponding processor signals are summarized in
Table 2-9.
Table 2-9. Push Button Connections
Push Button Label
PB1
PB2
PB3
PB4

Board Reset Push Button (SW12)

The push button (
RESET
exception is the USB interface chips. The chips are not reset when the
push button is pressed after the USB cable has been plugged in and com-
munication initialized correctly with the PC. After USB communication
has been initialized, the only way to reset the USB is by powering down
the board.
ADSP-21375 EZ-KIT Lite Evaluation System Manual
ADSP-21375 EZ-KIT Lite Hardware Reference
) are provided for general-purpose user input.
FLAG
) is capable of disconnecting the push
SW7
for more information.
Push Button Reference Designator
SW8
SW11
SW10
SW9
) resets all of the ICs on the board. The only
SW12
pins of the processor, while
) to the processor.
1
for more information.
"Push Button Enable
Processor Pin
FLAG1/IRQ1
FLAG0/IRQ0
DAI19
DAI20
2-17