Analog Devices Lite ADSP-21375 EZ-KIT System Manual page 25

Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
Using an Emulator:
1. Plug one side of the USB cable into the USB connector of the emu-
lator. Plug the other side into a USB port of the PC running
CCES.
2. Attach the emulator to the header connector
the EZ-KIT Lite board.
Using the on-board Debug Agent:
1. Plug one side of the USB cable into the USB connector of the
debug agent
ZJ1
2. Plug the other side of the cable into a USB port of the PC running
CCES.
Step 2: Attach the provided cord and appropriate plug to the 7V power
adaptor.
1. Plug the jack-end of the power adaptor into the power connector
on the EZ-KIT Lite board.
J4
2. Plug the other side of the power adaptor into a power outlet. The
power LED (labeled
board.
3. Power the emulator (if used). Plug the jack-end of the assembled
power adaptor into the emulator and plug the other side of the
power adaptor into a power outlet. The enable/power indicator is
lit green when power is applied.
Step 3 (if connected through the debug agent): Verify that the yellow
USB monitor LED (labeled
) on the debug agent are both on. This signifies that the board is
ZLED9
communicating properly with the host PC and ready to run CCES.
ADSP-21375 EZ-KIT Lite Evaluation System Manual
Using the ADSP-21375 EZ-KIT Lite
(labeled ).
USB
) is lit green when power is applied to the
LED9
)and the green power LED (labeled
ZLED3
(labeled ) on
ZP4 JTAG
1-5