Inserting And Removing The Rotor - Hettich EBA 280 Operating Manual

EN
12

Inserting and removing the rotor

Rotor with unlocking knob
A
Inserting the rotor:


B
Removing the rotor:

Rotor without unlocking knob
C
Inserting the rotor:

B
Removing the rotor:

12/45
Dirt particles between the motor shaft and rotor prevent the rotor from
having a perfect seat and cause it to run unsteadily.
If necessary, clean the motor shaft (B) and the rotor hub before inserting the
rotor.
Lift up the rotor by the unlocking knob (A) and place horizontally on the motor
shaft (B). The rotor will automatically engage on the motor shaft.
Hold the rotor firmly at the left and right and pull up lightly to check whether it
has properly engaged on the motor shaft.
Pull up the unlocking knob (A) on the rotor, hold onto it and lift the rotor from the
motor shaft.
Dirt particles between the motor shaft and rotor prevent the rotor from
having a perfect seat and cause it to run unsteadily.
If necessary, clean the motor shaft (B) and the rotor hub before inserting the
rotor.
Lift up the rotor by the handle (C), place it horizontally on the motor shaft (B) and
press down as far as it can go.
Hold the rotor firmly by the handle (C) and lift it off of the motor shaft.
Rev. 01 / 11.2022 AB1101EN_SA