Vecow EAC-5000 User Manual page 59

4.2.3 Connect EAC-5000 to the host computer
Step 1: Connect the power adapter to the EAC-5000. Connect the Micro
Step 2: Press and hold the "RECOV" button.
Step 3: While holding the "RECOV" button, power on the system. Continue to
Step 4: Now that the device is in recovery mode, issue "lsusb" command on
BUS 003 Device 005: ID 0955:7e19 Nvidia Corp.
4.2.4 Flash image to the EAC-5000
Step 1: Open a terminal on host PC, then access the package folder you
Step 2: Run the following script to install the right dependencies:
$ sudo ./l4t_flash_prerequisites.sh
Step 3: Run this command from the decompressed folder to flash the image:
$ sudo ./EAC-5000_flash.sh
©Vecow EAC-5000 User Manual
USB cable to the "Flash" Port on EAC-5000 and the other end to an
available USB port on the host PC. Make sure you have only ONE
EAC-5000 device in recovery mode plugged in the host.
hold the "RECOV" button for two seconds, and release.
host PC to find a new USB device:
extracted in step 4.2.2-3.
SOFTWARE SETUP 52