Table of Contents
Advertisement
O P E R A T I O N
M A N U A L
INPUT D/A MODULE
If you have a D/A-converter module and the module input is selected, you have the
option to select between the USB and the RCA input. Longer pressing the AUDIO
button (approx.
2
seconds) will switch the inputs.
SETUP MENUS
•
Longer pressing the MENU button (approx.
MENU. Shortly pressing MENU again will close the menu.
Shortly pressing the MENU button will open either the MAIN MENU or
•
RECORD MENU, depending on which level you are currently in. Shortly
pressing the MENU button again will close the menu.
•
Longer pressing the MODE button (approx.
PHONES MENU. Shortly pressing the MENU button will close the menu.
Shortly pressing the AUDIO button will open the PHONO MENU, if a Phono MM
•
or MC module is equipped and the module input is selected. Shortly pressing
the MENU button will close the menu.
•
Longer pressing the AUDIO button (approx.
if a Phono MC module is equipped and the module input is selected. Shortly
pressing the MENU button will close the menu.
•
Longer pressing the AUDIO button (approx.
MM MENU, if a Phono MM module is equipped and the module input is selected.
Shortly pressing the MENU button will close the menu.
6 4 | 7 6
seconds) will open the GLOBAL
2
2
seconds) will open the
2
seconds) will open the MC MENU,
2
seconds) will open the
BurLink
CONNECTIONS
Connections to the BURLINK interface can either be done by the
connector (RS-
232
) or by the USB connector.
RS-
232
configuration:
9600
Baud,
handshake A USB device driver needs to be installed when using the
USB connector. System requirements for using the USB software are either
WINDOWS 2000 or WINDOWS XP operating system.
COMMANDS
Listed below are the possible commands to control the preamp
needs to be sent in capital letters finished with a "carriage return" \r.
switches the unit on
POWON\r
POWOFF\r
switches the unit to standby mode
switches the inputs of the preamp
INP+\r
INP-\r
switches the inputs of the preamp
switches to input
INP1\r
INP2\r
switches to input
INP3\r
switches to input
INP4\r
switches to input
switches to input
INP5\r
INP6\r
switches to input
INP_MOD\r
switches to module input
switches between the inputs of the D/A converter module,
DAC_SRC_INP\r
if equipped
switches to the RCA input of the D/A converter module,
DAC_SRC_RCA\r
if equipped
switches to the USB input of the D/A converter module,
DAC_SRC_USB\r
if equipped
increases the volume by one step
VOLUP\r
0 7 7
P R E A M P L I F I E R
9
-pin D-SUB
8
bit, parity: none,
1
stop bit, no hardware
. All commands
077
1
2
3
4
5
6
6 5 | 7 6
Advertisement
Table of Contents
