Burlink - Burmester 035 Owner's Manual

Connecting to the BURLINK interface can be done either with the 9 pin D-SUB connector (RS-232) or with the USB
2.0 connector. A USB device driver needs to be installed when using the USB 2.0 connector.
System requirements for using the USB software are either WINDOWS 2000 or WINDOWS XP operating system.
Following are listed the possible commands to control the preamplifier 035. All commands needs to be sent in
capital letters finished with a "carriage return" \r .
POWON\r
POWOFF\r
PHONO\r
TUNER\r
CD\r
TAPE\r
AUX\r
SURR\r
VOLUP\r
VOLDN\r
MONITOR\r
MONITOROFF\r
MONITORON\r
TONE\r
TONEOFF\r
TONEON\r
BASSUP\r
BASSDN\r
TREBLEUP\r
TREBLEDN\r
DIM0\r
DIM1\r
DIM2\r
DIM3\r
DIM\r

BURLINK

CONNECTIONS
COMMANDS
switches the unit on
switches the unit to standby mode
activates the PHONO input
activates the TUNER input
activates the CD input
activates the TAPE input
activates the AUX input
activates the SURROUND input
increases the volume for one step
decreases the volume for one step
changes between monitor loop on or off
switches the monitor loop off
switches the monitor loop on
changes between tone control on or off
switches the tone control off
switches the tone control on
increases the bass volume for one step (2dB)
decreases the bass volume for one step (2dB)
increases the treble volume for one step (2dB)
decreases the treble volume for one step (2dB)
switches the display brightness to maximum
switches the display brightness to middle
switches the display brightness to low
switches the display to off mode
switches the brightness step by step (0,1,2,3,0,1,2....)
10