Table of Contents
Advertisement
O P E R A T I O N
M A N U A L
BALANCE
Some spatial arrangements require a shift of the volume ratio between the two
reproducing channels. The volume shift is realized by reducing one of the two
stereo channels. It is possible to alleviate one channel of the preamp
(factor
.
) in steps of
dB, and for specific situations to switch it off completely.
2
8
1
Select menu item M-BAL with the left rotary switch or the navigation
buttons ► ◄ on your remote control.
With the right rotary switch or the navigation buttons ▲ ▼ on your remote
control you may select the desired value:
both stereo channels of the MAIN level will be reproduced
<C>
at the same volume level
the right channel of the MAIN level will be reproduced with
-09R to -01R
reduced volume
OFF R
the right channel of the MAIN level is muted
the left channel of the MAIN level will be reproduced with
-09L to -01L
reduced volume
OFF L
the left channel of the MAIN level is muted
The balance setting has no effect on the SURROUND input.
FADER
PLEASE NOTE:
This menu item is only available when
activated.
The option Fader will allow you to increase or decrease the volume of the power
amp connected to the RECORD output in reference to the MAIN output. It is
possible to adjust the volume up to +/-
Select menu item FADER with the left rotary switch or the navigation
buttons ► ◄ on your remote control.
4 6 | 7 6
077
up to
9
dB
Channel Mode is
4
10
dB.
With the right rotary switch or the navigations buttons ▲ ▼ on your remote
control you may select the desired value:
the power amp connected to the RECORD output will
<C>
have the same volume as the power amp connected to
the MAIN output.
the power amp connected to the RECORD output will have
-10 to –01
a reduced volume in reference to the power amp connected
to the MAIN output. The steps are indicated in dB.
the power amp connected to the RECORD output will have
+10 to +01
a increased volume in reference to the power amp connec-
ted to the MAIN output. The steps are indicated in dB.
INITIAL VOLUME
This menu item preselects the volume for the MAIN level of your device when
it is switched on.
Select menu item M-VOL with the left rotary switch or the navigation
buttons ► ◄ on your remote control.
With the right rotary switch or the navigation buttons ▲ ▼ on your remote
control you may select the desired value:
The range of selection reaches from 01 to 20 and -79 dB to -60 dB respectively,
in single steps.
If the setting LAST is chosen, the volume that was last selected will be used.
For security reasons, this is only possible up to a maximum volume of 20 and.
-60 dB respectively.
VOLUME SCALE
This menu item preselects whether the Volume of the MAIN level is indicated in
BURMESTER or dB steps.
Select menu item M-SCALE with the left rotary switch or the navigation
buttons ► ◄ on your remote control.
With the right rotary switch or the navigation buttons ▲ ▼ on your remote control
you may select one of the following:
BUR
Volume indicated in BURMESTER steps (00 to 60)
dB
Volume indicated in dB steps (-99dB to +5dB or +21dB at high
amplification)
0 7 7
P R E A M P L I F I E R
4 7 | 7 6
Advertisement
Table of Contents
